Off-the-road (OTR) tyres keep construction sites, quarries, ports and mines moving. When a wheel loader or articulated hauler stands idle waiting for a tyre, the cost is far higher than the tyre itself. Yet OTR tyres are bought far less often than truck or passenger tyres, so the size codes, service codes and load tables can be unfamiliar even to experienced fleet buyers.
This primer explains how OTR tyres are described, how to match them to your machines and work, and what to have ready before you request a wholesale quote. It is written for construction fleets, plant-hire companies and the dealers who supply them across the UAE, the wider GCC and Africa.
1. What counts as an OTR tyre?
OTR tyres are built for machines that work mostly off public roads, at low speed and under very heavy load. The main groups are:
- ✓Earthmover and haulage tyres for dump trucks, articulated haulers and scrapers that carry loads over haul roads.
- ✓Loader and dozer tyres for wheel loaders and wheeled dozers that push into piles and work on rough, rocky ground.
- ✓Grader tyres for motor graders that shape and maintain roads.
- ✓Compactor tyres for pneumatic rollers.
- ✓Industrial tyres for forklifts, port equipment and similar machines. These include pneumatic and solid tyres and follow their own size systems, so treat them as a separate purchase.
Truck and bus radial (TBR) tyres on tipper trucks that run on public roads are not OTR tyres, even on a construction site. If your fleet mixes both, see PCR vs TBR tyres: the difference and our truck tyre programmes.
2. How to read an OTR size
Most construction OTR sizes follow one of two patterns:
| Example | What it means |
|---|---|
| 23.5-25 | Nominal section width 23.5 inches, a dash for bias (cross-ply) construction, fitted on a 25-inch rim. |
| 23.5R25 | The same nominal size in radial construction (R in place of the dash). |
| 16.00-25 | Older "wide base" notation: section width 16.00 inches, bias, 25-inch rim. |
Then check:
- ✓Ply rating (PR), for example 20PR or 28PR. This is a load-strength index, not a count of actual plies. A higher PR in the same size carries more load at a higher inflation pressure.
- ✓Tube type (TT) or tubeless (TL). Tube-type fitments need the matching tube and flap; tubeless fitments need a rim and O-ring in good condition.
- ✓Standard rim, for example 19.50/2.5, which gives rim width and flange height. Always fit OTR tyres on the rim the tyre maker lists for that size.
For general sidewall reading, see How to read a tyre size and sidewall.
3. Service codes: E-3, L-3 and the rest
OTR tyres carry a service code that tells you the type of machine and the tread type. The widely used Tire and Rim Association (TRA) system works like this:
- ✓The letter is the machine type: E = earthmover/haulage, L = loader and dozer, G = grader, C = compactor.
- ✓The number is the tread type: 1 = rib, 2 = traction, 3 = rock, 4 = rock with deep tread, 5 = rock with extra-deep tread, 7 = flotation.
So an E-3 tyre is a rock-tread tyre for haulage machines, and an L-3 tyre is a rock-tread tyre for loaders and dozers. Rock treads (3, 4 and 5) suit quarries, demolition and rough, stony ground; deeper treads give more rubber to wear and more protection against cuts. Choose the code for the machine and the ground you actually work on, not simply the code that came on the machine.
4. Load is rated by speed
Unlike road tyres, OTR load tables often list more than one load at more than one speed. The same tyre can carry much more at walking pace than at haul-road speed. For example, the official Falcon catalogue lists the Falcon OTR 23.5-25, 20PR at:
| Speed | Max load per tyre | Inflation pressure |
|---|---|---|
| 50 km/h | 7,300 kg | 300 kPa |
| 10 km/h | 10,900 kg | 375 kPa |
What this means for your fleet:
- ✓A loader that works at short distances and low speed can use the low-speed rating.
- ✓A hauler or tipper that travels at speed between the cut and the dump must be specified on the higher-speed rating, and long hot cycles add heat that the tyre has to shed.
- ✓Many tyre makers also publish a TKPH (tonne-kilometre-per-hour) rating for haulage tyres. Compare the TKPH of the tyre with your real cycle (average load × average speed) when choosing tyres for dump trucks.
Always set pressure cold, before the shift, using the tyre maker's table for the load and speed you actually run.
5. Practical care on site
- ✓Keep haul roads and loading areas clean. Loose rock and sharp debris cause most cuts and early failures. A grader pass costs far less than a set of tyres.
- ✓Check pressure every shift when tyres are cold, and record it. Under-inflation flexes the sidewall and builds heat.
- ✓Avoid wheel spin at the face of the pile; it wears rock treads quickly.
- ✓Match tyres on the same axle by size, construction (bias or radial) and tread depth.
- ✓Inspect daily for cuts, bulges, exposed cords and damage around the bead and valve.
- ✓Use trained fitters and proper equipment. OTR wheels with lock rings and high pressures are dangerous to service without training and a safety cage.
- ✓Store spares properly, out of sunlight, away from heat and ozone sources. See Tyre storage best practice for warehouses and dealers.
For a wider fleet programme, see Fleet tyre management in the UAE and GCC.
6. What to send with an OTR quote request
To get an accurate wholesale offer, send:
- ✓1. Machine type and model (for example, wheel loader, articulated hauler, grader).
- ✓2. Tyre size as shown on the current tyre, including PR and TT/TL.
- ✓3. Service code you need (for example, E-3 or L-3) and the ground conditions.
- ✓4. Quantities, and whether you need tubes and flaps for tube-type fitments.
- ✓5. Delivery point: local delivery or export by container, and the destination port.
The Falcon OTR range
Falcon is a Golden Extreme house brand. The official Falcon TBR & OTR Tyre Catalogue 2026 lists Falcon OTR tyres for construction machines, mining equipment, loaders, dozers and similar machinery, in 7 sizes on 25″ rims with service codes E-3 / L-3:
| Size | Ply ratings listed | Type |
|---|---|---|
| 15.5-25 | 12, 16 | TT/TL |
| 16.00-25 | 28, 32, 36 | TT/TL |
| 17.5-25 | 16, 20 | TT/TL |
| 20.5-25 | 20, 24, 28 | TT/TL |
| 23.5-25 | 20, 24, 28 | TT/TL |
| 26.5-25 | 28, 32 | TL |
| 29.5-25 | 28, 34 | TL |
Full tread depth, rim, width, diameter, load and pressure data for every size are in the catalogue. Download it from Catalogues, or see the range on Falcon Tyres and Truck tyres. Tubes and flaps for tube-type fitments: Tubes and flaps.
How Golden Extreme can help
Golden Extreme Group has supplied wholesale tyres, batteries and wheels since 2014, from bases in Dubai and Sharjah, with 150,000+ sq ft of warehouse space and container export from Jebel Ali. Alongside our house brands, Falcon and Tubroo, we offer the wider range of brands we supply.
- ✓OTR and truck tyres: Truck tyres · Falcon Tyres · Catalogues
- ✓Export by container: Export from Jebel Ali
- ✓Dealers and distributors: Become a distributor
- ✓Ask us: Contact, +971 4 222 9799, WhatsApp +971 58 649 8398, info@goldenextreme.com
FAQ
What does OTR mean on a tyre?
OTR means off-the-road. OTR tyres are built for construction, quarry, port and mining machines such as wheel loaders, dozers, graders and haulers that work mostly off public roads, at low speed and under heavy load.
What is the difference between E-3 and L-3 OTR tyres?
Both are rock-tread tyres under the widely used TRA service-code system. E-3 is for earthmover and haulage machines such as dump trucks and articulated haulers; L-3 is for loaders and dozers. Choose the code for the machine and the ground it works on.
What does 23.5-25 mean on an OTR tyre?
It means a nominal section width of 23.5 inches, bias (cross-ply) construction shown by the dash, on a 25-inch rim. A radial tyre in the same size is written 23.5R25.
Why do OTR tyres list different loads at different speeds?
A tyre builds more heat at higher speed, so it can carry less load. OTR load tables often give one load for slow work such as loading and a lower load for travelling at haul-road speed. Set pressure cold, using the maker's table for your real load and speed.
Which OTR tyres does Golden Extreme supply?
The official Falcon TBR & OTR Tyre Catalogue 2026 lists Falcon OTR tyres in 7 sizes on 25-inch rims, from 15.5-25 to 29.5-25, with E-3 / L-3 service codes. Contact our team for availability and other OTR sizes.
Can Golden Extreme export OTR tyres by container?
Yes. Golden Extreme ships wholesale orders by container from Jebel Ali. Contact our team on +971 4 222 9799, WhatsApp +971 58 649 8398 or info@goldenextreme.com with your sizes, quantities and destination port.
Golden Extreme supplies wholesale OTR and truck tyres from Dubai. Contact our team on +971 4 222 9799, WhatsApp +971 58 649 8398 or info@goldenextreme.com with your sizes, quantities and destination.
Contact →